Loading ...
Loading ...
Loading ...
needed.Removethebeltcoverandmovethehexnuts
at theotherendof thecabletowardstheend of the
casing. Then readjust the hex nuts at the handle.
TirePressure
The tires on your unit may be over-inflated for shipping
purposes. Reduce the tire pressure before operating
the unit. Recommended operating tire pressure is
approximately 20 p.s.i. (check sidewall of tire for tire
manufacturer's recommended pressure).
WARNING: Maximum tire pressure
under any circumstances is 30 p.s.i. Equal
tire pressure should be maintained on
both tires.
SECTION3: KNOWYOURTILLER
Handle
Lock
Figure 6
GearSelectionHandle
The gear selection handle is located in the center of the
handle on the tiller. It is used to select NEUTRAL,
REVERSE, or one of the FORWARD mode. Pull or
push the handle so that the indicator on top of shift
cover points to the operating mode desired.
See Figure 6.
Neutral
Transmission is in neutral.
Reverse
Reverse wheel drive.
ForwardModes
Wheels Forward: Forward wheel drive only.
Tines Reverse: Forward wheel drive and reverse tine
drive.
Tines Forward: Forward wheel and tine drive.
IMPORTANT: Use the reverse tine drive when tilling
virgin ground, sod, or hard soil. Use the forward tine
drive when cultivating or tilling soft ground.
NOTE: If difficulty is encountered in moving the gear
selection handle, refer to following helpful hints. To shift
into forward or reverse wheel drive, move tiller forward
slightly then backward to allow the gears to
synchronize.
To shift intoforward wheels and tine drive, push
forward slightly on the gear selection handle and slowly
engage the clutch control allowing the gears to
synchronize. To stop forward movement and tine drive,
release the clutch control. Do not shift gears with the
clutch control engaged except when engaging the
tines.
Loading ...
Loading ...
Loading ...