Loading ...
Loading ...
Loading ...
P a g e |
24
web: brohn.com.au
0.72
Semi-rapid
6.6
3.24
0.53
Auxiliary
3.7
1.8
Reassemble all burners carefully; in particular you should ensure that the flame
spreader is correctly placed on the burner.
IMPORTANT: The minimum flow adjustment process must be completed before the
appliance is used.
MINIMUM FLOW ADJUSTMENT FOR HOB GAS TAPS
All work must be carried out by a licensed gas fitter.
IMPORTANT: Always isolate the hob from the electricity supply before
changing the injectors and/or adjusting the minimum flow of the burners.
Remove all the pan supports, caps, flame
spreaders and knobs.
Unscrew the screws of the panel, then
remove the panel.
Install cap, flame spreader and knob of the
burner. Switch the burner on and set the
knob at the minimum position.
Place a small bladed screwdriver on the
screw to adjust the minimum flow (as shown
in the image on the left).
Unscrew the adjusting screw in order to
increase the gas flow or tighten the adjusting
screw to decrease the gas flow.
The correct adjustment is obtained when the
flame has a length of about 3 – 4 mm.
For butane/propane gas the adjusting screw must be tightly
screwed in.
Make sure that the flame does not go out by quickly turning from
maximum flow to minimum flow. If it does then remove the
control knob and make further adjustments to the gas flow,
testing it again once the adjustment has been made.
Repeat this process for each one of the gas taps.
Install the panel and refit the caps, flame spreaders and knobs
after finishing the adjustment.
Loading ...
Loading ...
Loading ...