Loading ...
Loading ...
Loading ...
12 BISSELL.com
4
21
Place vacuum upside down with brush
roll facing upwards. Remove 5 screws
with a Phillips-head screwdriver.
Lift off brush cover and grasp floor
brush at both ends to lift out. Check
drive belt carefully for wear, cuts
and stressed areas. If the drive belt
appears worn, replace as needed.
When finished, align brush roll with
belt turning by hand several times in
the direction of the motor to align the
belt on the floor brush.
Grasp old drive
belt and remove
from motor shaft to
discard. Loop new
drive belt over motor
shaft and stretch
other end over floor
brush in the space
provided between
the bristles.
Replace the brush cover and 5 screws.
3
65
Test the brush by holding
on end and spinning. It
should spin freely several
revolutions from one flick.
If not, the brush will need
to be replaced.
Replacing the Drive Belt
WARNING
To reduce the risk of electric shock, turn power switch OFF and disconnect plug from electrical outlet
before performing maintenance or troubleshooting checks.
Loading ...
Loading ...
Loading ...