Loading ...
Loading ...
Loading ...
9
OPERATING YOUR WATER DISPENSER
OPERATION INSTRUCTIONS
Before Using Your Water Dispenser
•
Check to be sure the following parts are included:
§
Instruction manual
•
Before connecting the appliance to the power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
•
The water dispenser is pre-cleaned at the factory, but the reservoir and water
lines must be flushed with fresh water before use as follows:
•
Keep the unit unplugged.
•
Fill water tank with tap water full to capacity (more than 3/4 of a gallon). Wait for 5
minutes until water settles.
•
Plug the dispenser into the electrical outlet Power light will illuminate. Turn on the
HOT and COLD power switches at the rear of the unit, the HOT and COLD indicator
lights will illuminate and now we are ready to complete the first cycle. In order to do
that, wait for the cold water indicator light to go off (another 40 minutes,
approximately).
•
Unplug the dispenser from the electrical outlet. Proceed to drain the water from the
faucets one at a time until no more water remains.
(Note: To facilitate this operation, use a large container).
•
Then, drain any water left in the tanks by opening the drain plug located on the back,
until it drains completely.
•
Proceed to close the drain cap.
•
Place the standard 2, 3 or 5-gallon bottle of water on the water inlet, allow water to
stand for approximately one minute.
•
Open water faucets to insure water flows from both faucets.
•
Plug dispenser into the electrical outlet.
•
Now you are ready to use your water dispenser.
NOTE: Your water dispenser has been cleaned and sanitized before leaving the
factory, but in case a taste problem develops, place two tablespoons of
baking soda and add tap water. Fill water tank again and repeat basic
operations previously outlined.
~WARNING~
IMPROPER USE OF THE GROUNDED PLUG CAN RESULT IN THE RISK OF ELECTRICAL SHOCK. IF
THE POWER CORD IS DAMAGED, HAVE IT REPLACED BY AN AUTHORIZED AVANTI PRODUCTS
SERVICE CENTER.
Loading ...
Loading ...
Loading ...