Loading ...
Loading ...
Loading ...
13INSTALLATION
ENGLISH
Install the washer on a solid oor that is strong and
even when fully loaded, without exing or bouncing.
If the oor has too much ex, you may need to
reinforce it to make it more rigid. If the oor is not
• Before installing the washer, make sure the oor
that can move or slide on the oor can contribute to
the oor.
•
sure the leveling feet are adjusted for rm and even
• Allow for sufcient space between the walls and the
•
•
•
•
•
•
•
qualied service personnel.
•
be installed on a solidly constructed oor.
• The washer must be installed on rm ooring to
ooring is best, but a wood oor is sufcient,
•
be installed on a solidly constructed oor.
•
Unpacking and Removing
Shipping Bolts
1
Lift the washer off the foam base.
After removing the carton and shipping material,
lift the washer off the foam base. Make sure the
plastic tub support comes off with the base and
is not stuck to the bottom of the washer.
If you must lay the washer down to remove the
base packaging materials, always protect the
side of the washer and lay it carefully on its side.
Do not lay the washer on its front or back.
Foam tub
support
Carton base
2
Remove the bolt assemblies.
Starting with the bottom two shipping bolts, use
the wrench (included) to fully loosen all four
shipping bolts by turning them counterclockwise.
Remove the bolt assemblies by wiggling them
slightly while pulling them out.
Shipping
bolt
NOTE
• Save the bolt assemblies for future use. To prevent
damage to internal components, do not transport
the washer without reinstalling the shipping bolts.
• Failure to remove shipping bolts and retainers may
cause severe vibration and noise, which can lead
to permanent damage to the washer. The cord is
secured to the back of the washer with a shipping
bolt to help prevent operation with shipping bolts in
place.
Loading ...
Loading ...
Loading ...