Loading ...
Loading ...
Loading ...
Installation
18
This appliance is suitable for connection
with rigid pipe or flexible hose. The isolating
manual shut-off valve connection point must
be accessible when the appliance is
installed.
Flexible hose assembly must be certified to
AS/NZS 1869 class B or D, be of
appropriate internal diameter for the total
gas consumption (10 mm), be kept as short
as possible (not exceeding 1200 mm), must
not be in contact with the floor or any other
hot surface or sharp surface. The hose
assembly must not be subject to strain,
abrasion, kinking or deformation, contact
with any other appliance or accidental
contact with oven flue outlet of an under
bench oven.
Gas leakage and operation of the
appliance must be tested by the installer
before leaving. Check burner flames are
blue in colour, stable and completely ignite
at both high and low flame settings with no
appreciable yellow tipping, carbon
deposition, lifting, floating, lighting back or
objectionable odour. Test burners
individually and in combination. When
satisfied with the operation of the cooker,
please instruct the user on the correct
method of operation.
Natural Gas: the pressure regulator must
be fitted to the appliance inlet connection.
Gas pressure must be adjusted to 1.0 kPa
when approximately 50% of the burners are
on high flame, the appliance test point is
located on the regulator.
ULPG: the supplied test point adaptor must
be fitted to the appliance inlet connection.
Gas pressure must be checked to 2.75 kPa
when approximately 50% of the burners are
on high flame.
5.3 Section cut from the countertop
Create an opening with the dimensions
shown in the figure in the countertop of the
piece of furniture.
5.4 Mounting
Over built-in oven unit
The clearance between the hob and the
kitchen furniture or other installed
appliances must be enough to ensure
sufficient ventilation and air discharge.
The following operation requires
building and/or carpentry work
and must therefore be carried out
by a competent tradesman.
Installation can be carried out on
various materials such as masonry,
metal, solid wood or plastic
laminated wood as long as they
are heat resistant (>90°C).
L (mm) X (mm) Y (mm)
380 252 - 256 482 - 486
650 560 - 564 482 - 486
750 560 - 564 482 - 486
900 844 - 848 482 - 486
Loading ...
Loading ...
Loading ...