Loading ...
Loading ...
Loading ...
3. Make sure that the product works correctly. Examine
that all nuts and screws are tight.
4. Make sure that the handle and safety devices are
not damaged and are attached correctly. Do not
operate a product with missing parts or is changed
from its initial specification. Use protective gloves
when it is necessary.
5. Make sure that the covers are not damaged and are
attached correctly, before you operate the product.
To start the product
1. Push the on/off button until the green LED comes
on. (Fig. 34)
2. Push the front handle trigger on the front handle.
(Fig. 35)
3. Push the power trigger. (Fig. 36)
To operate the product
1. Start near the ground and move the product up
along the hedge when you cut the sides. Make sure
that the body of the product does not touch the
hedge. (Fig. 37)
WARNING: Make sure that the
front of the cutting equipment does not
touch the ground.
2. Hold the product near your body for a stable work
position.
3. Be careful and operate the product slowly.
Automatic shutdown function
The product has an automatic shutdown function that
stops the product if it is not used. The product shuts
down after 3 minutes.
To stop the product
1. Release the power trigger and the front handle
trigger.
2. Push the on/off button until the green LED goes off.
3. Push the release buttons on the battery and remove
the battery. (Fig. 38)
Maintenance
Introduction
WARNING: Read and understand the
safety chapter before you do maintenance
work on the product.
WARNING: Remove the battery before
you do maintenance on the product.
Maintenance schedule
The following is a list of the maintenance steps that you
must do on the product.
Maintenance Before
use
Weekly Monthly
Clean the external parts of the product. X
Examine that the start and stop switch works correctly and is not damaged. X
Make sure that the power trigger and the front handle trigger function correctly
from a safety point of view.
X
Make sure that all controls work and are not damaged. X
Make sure that the cutter blade and cutter guard have no cracks and that they
are not damaged. Replace the cutter blade or the cutter guard if they have
cracks or if they have been exposed to impact.
X
Replace the cutter blade if it is bent or damaged. X
Make sure that the hand guard is not damaged. Replace the guard if it is dam-
aged.
X
Make sure that the screws and nuts are tight. X
Make sure that the battery is not damaged. X
334 1888 - 004 - 22.09.2022
Loading ...
Loading ...
Loading ...