Loading ...
Loading ...
Loading ...
8 — English
OPERATION
WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict severe injury.
WARNING:
Always remove battery pack and nails from the tool before
leaving the work area, moving the tool to another location,
handing the tool to another person, assembling parts,
cleaning, or when not in use. Always remove battery pack
when making adjustments. Failure to do so could result
in serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes, resulting in possible
serious injury.
NOTICE:
If the tool is exposed to temperatures below 32ºF for
long periods of time it may not operate. Allow the tool to
warm up prior to use. If the tool is used in excessively high
temperatures more than 104ºF for prolonged periods, the
unit may not operate properly or it may shut down. Allow
the tool to cool before resuming normal use.
APPLICATIONS
You may use this tool for the purposes listed below:
Framing
Floor Decking
Exterior Decks
Engineered Lumber
Blocking Sub-Assemblies
Fencing
Crate and Box Assembly
Trusses
Pallets and Pallet Repair
Subflooring
WARNING:
Always wear eye protection. Eye protection does not fit
all operators in the same way. Make sure the eye protec-
tion chosen has side shields or provides protection from
flying debris both from the front and sides.
ATTACHING THE BELT CLIP
See Figure 1, page 13.
The belt clip can be installed on the left or right side of the
nailer, depending on operator preference.
Align belt clip and screw with right or left side screw hole.
Using a Phillips head screwdriver (not included), tighten
securely.
INSTALLING/REMOVING BATTERY PACK
See Figure 2, page 13.
NOTE: Use of a 3Ah or higher battery is recommended for
the best performance.
To install, place the battery pack in the tool. Align raised
rib on battery pack with the groove inside the tool.
NOTE: During battery installation the battery foot will
move, this is an intentional design.
Make sure the latches on both sides of the battery pack
snap into place and the battery pack is secured in the
tool before beginning operation.
NOTE: Squeeze grip switch to activate nailer.
To remove, locate latches on both sides of the battery
pack and depress to release the battery pack from the
tool.
For complete charging instructions, see the operator’s manu-
als for your battery pack and charger.
NO-MAR PAD
See Figure 3, page 13.
The no-mar pad attached to the nose of the tool helps prevent
marring and denting when working with softer woods.
WARNING:
Remove the battery pack from the tool before removing
or replacing the no-mar pad. Failure to do so could result
in serious personal injury.
The pad can be removed by pulling it down and away from
the nose. To replace the pad, fit it into place over the nose
and push up at the back to reseat.
LOADING THE TOOL WITH NAILS
See Figures 4 and 5, page 13.
Remove battery pack from the tool.
With the nose of the tool pointed away from you, feed
a strip of nails into the magazine. Be sure the nails are
pointed downward and at the angle shown.
OPERATION
Loading ...
Loading ...
Loading ...