Loading ...
Loading ...
Loading ...
WARNING
Trouble Probable Cause Suggested Remedy
For your own safety turn off power at fuse box or circuit breaker before trouble shooting your fan.
1. FAN WILL NOT START.
2. FAN SOUNDS NOISY.
3. FAN WOBBLES
EXCESSIVELY.
4. REMOTE CONTROL DOES
NOT WORK. THE CONTROL
INDICATOR LED IS
CONSTANTLY FLASHING.
5. NOT ENOUGH AIR
MOVEMENT.
1. Fuse or circuit breaker blown.
2. Loose power line connections to the fan, or loose
switch wire connections in the switch housing.
3. Dead battery in remote control.
1. Blades not attached to fan.
2. Loose screws in motor housing.
3. Screws securing fan blade holders to motor
flywheel are loose.
4. Wire connectors inside housing rattling.
1. Setscrew in downrod support is loose.
2. Setscrew in downrod/hanger ball assembly is loose.
3. Screws securing fan blade holders to blades are loose.
4. Blade holders not seated properly.
5. Hanger bracket and/or ceiling outlet box is not
securely fastened.
5. Motor noise caused by solid state variable speed control.
6. Screws holding blades to blade holders are loose.
Troubleshooting
Periodic cleaning of your new ceiling fan is the only
maintenance necessary.
When cleaning, use only a soft brush or lint free cloth to
avoid scratching the finish.
Abrasive cleaning agents are not required and should be
avoided to prevent damage to finish.
Periodic light dusting of the blades is recommended.
A feather duster will work best.
Avoid using water, cleansers, or harsh rags, which
can warp and ruin the blades.
CAUTION
Do not use solvents when cleaning your ceiling fan. It
could damage the motor or the blades and create the
possibility of electrical shock.
How to Clean Your Ceiling Fan Blades
Maintenance
21
1. Check main and branch circuit fuses or circuit breakers.
2. Check line wire connections to fan and switch wire
connections in the switch housings.
CAUTION: Make sure main power is turned off !
CAUTION: Make sure main power is turned off !
3. Replace with fresh battery.
1. Attach blades to fan before operating.
1. The battery/batteries are going to run out. 1. Please replace the battery/batteries.
2. Check to make sure all screws in motor housing are
snug (do not overtighten).
3. Check to make sure the screws which attach the fan
blade holders to the motor flywheel are tight.
1. Tighten both setscrews securely in downrod support.
2. Tighten the setscrew in the downrod/hanger ball assembly.
3. Check to be sure screws which attach the fan blade
holders to the blades are tight.
4. Check to be sure the fan blade holders seat firmly and
uniformly to the surface of the motor housing. If holders
are seated incorrectly, loosen the screws and retighten.
1. If possible, consider using a longer downrod (not included,
you can buy the longer downrod from fanimation.com).
5. Tighten the hanger bracket screws to the outlet box,
and secure outlet box.
4. Check to make sure wire connectors in switch
housing are not rattling against each other or against
the interior wall of the switch housing.
5. Some fan motors are sensitive to signals from solid-state
variable speed controls. Solid-state controls are not
recommended, choose an alternative control method.
6. Tighten screws securely.
Loading ...
Loading ...
Loading ...