Loading ...
Loading ...
Loading ...
Install the mounting bracket.
If you’re wiring your Video Doorbell, feed
your doorbell wires through the hole in
the mounting bracket first.
Using a Philips head screwdriver, drive the
screws into your wall (or into the anchors,
if installed) until they are flush with the
mounting bracket.
Connect the wires. (optional)
Connect the wires coming out of your wall
to the screws on the back of your Video
Doorbell. Either wire can connect to either
screw. The order doesn’t matter.
Your Video Doorbell is compatible with
doorbell systems supplying 8–24 volts AC,
50mA, at 50 or 60Hz, 40VA max.
If wiring directly to a doorbell transformer,
connect a 25 ohm, 50W wirewound resistor
in series with one of the doorbell wires to
protect your Video Doorbell.
Do not connect to a DC transformer, halogen
or lighting transformer, or intercom.
Steps for wiring to an existing doorbell
Attach your Video Doorbell
to the mounting bracket.
Hook the slot on the rear of your Video
Doorbell onto the tab near the top of the
mounting bracket.
Then, let the Doorbell pivot down to sit
flush on its bracket.
Secure your Video Doorbell.
Security Screw Wood Screw
CAUTION!
If you use the wrong screws to secure
the Video Doorbell, you could damage
the battery during installation, create a
fire hazard, and be seriously injured.
DO NOT USE any screw other than
the included short security screws
when securing your Video Doorbell
to the bracket.
Use the star-shaped end of the included
screwdriver to drive the two security
screws into the bottom of your
Video Doorbell.
Your Video Doorbell is now ready to use.
If you wired in your Video Doorbell, you
can now restore power at the breaker.
To review your warranty coverage, please visit
ring.com/warranty
© 2020 Ring LLC or its aliates.
Ring and all related marks are trademarks of Ring LLC
or its aliates.
For additional help, visit: ring.com/help
Or give us a call:
US 1 800 656 1918
Canada 1 855 300 7289
Worldwide +1 310 929 7085
For a list of all our customer support
numbers, visit: ring.com/callus
Mark the screw holes.
Use the bracket as a template to mark
the four corner holes. The recommended
install height is 4 feet above the ground.
Install the anchors. (optional)
If installing on stucco, brick, or concrete,
mark 4 drill holes. Use a 1/4” masonry drill
bit to drill holes in your wall, then insert
the included anchors.
If you’re installing on wood, skip this step.
Loading ...
Loading ...