Loading ...
Loading ...
Loading ...
5
INSTALLATION INSTRUCTIONS
Before
Using
Your
Appliance
•
Remove the exterior and interior packing.
•
Check to be sure you have all the following parts:
•
Set of pop-out keys
• 1 instruction manual
• Before connecting the appliance to the power source, let it stand upright
for approximately 2 hours or let the compressor complete three on/off
cycles to assure that the temperature inside is appropriate for the products
before loading them into the appliance. This will reduce the possibility of a
malfunction in the cooling system from handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
Locating
your
Appliance
• Move the appliance as close as possible to its final location, before
removing the skid.
• Use a screwdriver to remove the screws that fix the skid to the cooler
or metal supports, if applicable.
•
Place the cabinet on a surface solid enough to prevent vibration and strong
enough to support the combined weight of the cabinet and the product
load. Estimate 35 pounds per cubic foot of storage space.
•
Cabinets should never be placed in front of windows or glass doors where
sunlight will be in direct contact with the units. If a cabinet is located near a
window or glass door, provide an adequate shade to block the sun´s rays.
•
Ambient temperature must be between 59°F (15°C) and 86°F (30°C). Low
ambient temperatures below 50° F are as harmful as high ambient
temperatures. Extreme temperatures will affect the performance of the
cabinet.
NOTE:
Failure to properly level the cabinet could hinder proper drainage and
door operation. Leveling legs are provided with the cabinets. Level
the cabinet by adjusting the leveling legs as needed.
•
Leave a space of at least 8in (203mm) between the back, sides, and top of
the cabinet to provide adequate air circulation of the unit compartment.
Loading ...
Loading ...
Loading ...