Loading ...
Loading ...
2
SETUP & OPERATION
STEP 1: OPEN SECURITY BOX & INSTALL BATTERIES
For your convenience, we have included 4 “AA” Batteries that provide the power for the electronic
keypad. These must be installed before using your box. If your safe is locked, you may use the
Emergency Key to open it.
1. Remove the Black Emergency Key Cover.
1.
2. Insert the Emergency key and turn ¼ turn to the left
(counterclockwise).
2.
3. Turn the Open/Close knob ¼ turn to the left
(counterclockwise) and open the lid.
3.
4. Remove the Battery Compartment cover by pushing in
and sliding down.
4.
5. Install the batteries as pictured on the inside of the
Battery compartment. Ensure the batteries are installed
in the correct direction, with regard to polarity (+ and -)
5.
6. Once the batteries are properly installed, replace the
battery compartment cover.
Close Lid, Return Knob & Key to “Locked” position and
replace Emergency key cover.
6.
IMPORTANT: The starter batteries included with this product are for testing purposes only and
should be immediately replaced with new alkaline or lithium batteries. It is NOT RECOMMENDED to
use Non-alkaline or rechargeable batteries.
NOTE: If batteries are removed or fail, the keypad memory will NOT be erased and the active
programmed code will still work once power has been restored.
Weak or dead batteries should be replaced immediately and all 4 batteries should be changed. To
replace the batteries please follow the instructions in the SETUP section. Remember to always
remove batteries from safe if not using for an extended period of time. If your batteries are
completely dead and you cannot open the safe by using the digital keypad, use the override access
key to open safe and access the battery compartment.
Loading ...
Loading ...
Loading ...