Loading ...
Loading ...
Loading ...
12
Installation (continued)
5
Attaching Side Curtains to Window
□ Pull the left-hand side curtain out until it ts into the window
channel.
□ Use a 1/8 inch (3 mm) drill bit to drill a starter hole through
the hole in the curtain housing (B) .
□ Insert one of the 3/4 inch (19 mm) screws (C) through the
left-hand curtain housing (B) and into the window sash (A).
□ Remark a line on the EVA foam (JJ) according to less 1 /8
inch (3 mm) than the measured width, then cut the EVA
foam (JJ) along the line.
JJ
□ Remove the backing from the EVA foam (JJ). Attach one
EVA foam (JJ) on the curtain housing (A), the side with
adhesive should facing the curtain housing.
A
A
JJ
JJ
□ Repeat for the right-hand curtain.
C
C
B
B
A
A
NOTE:
The remaining steps on this page are only
applicable for E-star models,with E-star LOGO on the control
panel.
□ Put one EVA foam (JJ) on the curtain housing.
□ In order to minimize air leaks and ensure optimal
insulation, it is necessary to install the EVA Foam (JJ)
on
the curtain housing.
□ After the unit is installed to the window, measure the inner
width of the side curtain as shown.
□ Repeat for the left-hand curtain.
Loading ...
Loading ...
Loading ...