Loading ...
Loading ...
Loading ...
6
UNDER CABINET INSTALLATION
MODEL NO.:
CHX3830SQBD
-
3 (30”)
CHX3836SQBD-3 (36”)
Preparation before Installation
- Temporarily wire the hood to test for proper
operation before installing. If the hood
does not operate, check the circuit
breaker or house fuse. If the hood is still
not working, disconnect power supply and
check the continuity of all wire
connections.
- Peel protective film off the hood (if any).
- For installing under the cabinet with
recessed bottom, attach 4-inch wide wood
filler strips (not included) on each side.
(Figure 1)
- Using reference on Page 13 to measure and
create access opening for electrical wires
and exhaust under the cabinet.
Hood Installation
CAUTION
: If moving the cooking range
is necessary to install the hood, turn off the
power in an electric range at the main
electrical box. SHUT OFF THE GAS
BEFORE MOVING A GAS RANGE. And use
a protective covering to protect cooktop
and/or countertop from damage.
1. Remove the bottom casing or baffle
filters/stainless steel spacers if necessary;
arrange the electrical wires to run through
the 1” diameter hole on the top or the rear of
the hood.
2. Using references on Table 1 and
measurements on page 13, center the hood
in place beneath the cabinet and flush with
the front of the cabinet.
3. Draw electrical wires through cabinet
access opening.
4. Use electrical drill to remove the knockout
holes on top of the range hood.
5. Place screw (not provided) into the exact
center of each knockout hole. Make sure all
screws are in place before tightening
screws.
CAUTION
: MAKE SURE THE HOOD IS
SECURE BEFORE RELEASING.
Figure 1
Loading ...
Loading ...
Loading ...