Loading ...
Loading ...
Loading ...
Accessories Required
IMPORTANT: Line pressure or hose
inside diameter should be increased
to compensate for unusually long air
hoses (over 25 feet). Minimum hose
diameter should be 3/8" I.D. and
fittings should have 1/4" NPT thread.
Operation
Before each use:
• Drain water from air compressor
tank and condensation from
air lines. See air compressor's
operators manual.
_ isconnect
the ratchet
wrench from the air supply
before lubricating or
changing sockets.
Lubricate tool, see "Maintenance"
section in this manual.
_ Impact
wrench
sockets and accessories
must be used with this tool.
Do not use hand sockets
and accessories.
Select the required impact
socket. This tool has a 3/8"
square drive, use 3/8" deep
sockets. Use 3/8" extensions only
Connect tool to air hose of
recommended size. NOTE: The
use of a quick connect set makes
connecting easier.
IMPORTANT: The use of air
filters and air line lubricators is
recommended.
To use:
• Turn air"compressor on and allow
air tank to fill.
• Set the air compressor's regulator
to 90 PSI. This tool operates at a
maximum 90 PSI pressure.
• Place tool in forward or reverse
position.
Bu_on
Throttle
Control
Lever
/
F
Air Inlet
• Depress the throttle control
lever to operate tool. NOTE:
The throttle control lever
provides instant response when
depressed.
• Release throttle control lever to
stop tool.
• Always disconnect air supply
when changing sockets.
• When job is complete, turn the
air compressor off and store as
described in the air compressor
operator manual.
Tips
• Drive the fastener until the ratchet
stalls and then further tighten
by operating the air ratchet in
the same manner as a manually
dperated ratchet.
Loading ...
Loading ...
Loading ...