Loading ...
Loading ...
Loading ...
18
Ice Making Assembly System Cleaning
Minerals that are removed from water during the freezing cycle will eventually form a hard
scaly deposit in the water system. Cleaning the system regularly helps remove the mineral
scale buildup. How often you need to clean the system depends upon how hard your
water is. With hard water of 4 to 5 grains/liter, you may need to clean the system as often
as every 6 months.
5. Turn off the ice maker. Keep the ice maker connected to the water supply and drain
pipe. But shut off the water faucet of the main water supply.
6. Open the door and scoop out all of the ice cubes. Either discard them or save them in
an ice chest or cooler.
7. Making the cleaning solution. Please mix the Nu-Calgon Nickle Safe Ice Machine
Cleaner with water to make the cleaning solution.
Use a plastic or stainless container with more than 4 liters capacity, mix 300 ml
Nu-Calgon Nickle Safe Ice-machine Cleaner with 2.8 liters warm water about
120℉-140℉
,
Then divide them for 2 shares equally in 2 cups. It is better to keep the
temperature of each cup of the cleaning solution.
1.
2. Turn on the power to the ice maker, then press “TIMER CLEAN”button on control
panel for more than 5 seconds, to enter the self-Cleaning program. Same as above
explanation, the water pump runs for 8 minutes and stops for 3 minutes, one cycle,
again one cycle. The total duration time is 30 minutes for one self-cleaning
program.
During this process, the “CLEAN”light will always be on during this period, and the
digit window will indicate the left time,
3. After 30 minutes of one self-cleaning program completing, pull out the drain pipe of
the water tank, drain the cleaning solution down to the lower ice storage bin. Shake
the unit slightly to drain out all of the cleaning solution completely. Then install back
the drain pipe to the slot of the water tank.
4. Repeat steps 4--6 to clean the ice making assembly system again.
WARNING
Wear rubber gloves and safety goggles（and/or face
shield）when handing Ice Machine Cleaner or sanitizer.
Check to be sure that the water drain pipe of the
water tank has been installed properly in the slot
of the tank wall. Then pour one cup of
Nickel-Safe Ice Maker Cleaning Solution into the
water tank. Wait about for 5 minutes.
Loading ...
Loading ...
Loading ...