Loading ...
Loading ...
Loading ...
4 5
• This appliance is for household use only.
• Disconnect the appliance from its power source during service and when replacing parts
and cleaning.
• Please note: Check the nameplate for the type of refrigerant gas used in your appliance.
• Specific information regarding appliances with refrigerant gas.
• Do not pierce the cooling circuit of the machine. At the end of its useful life, deliver the
appliance to a special waste collection centre for disposal.
• GWP (Global Warming Potential): R410A: 2088, R134a: 1430, R290: 3, R32: 675.
• This hermetically sealed system contains fluoridated greenhouse gases.
• ENVIRONMENTAL INFORMATION: This unit contains fluoridated greenhouse gases covered
by the Kyoto Protocol.
• Do not use this unit for functions other than those described in this instruction manual.
• Make sure the plug is plugged firmly and completely into the outlet. Failure to firmly secure
the plug in the outlet may result the risk of electric shock or fire.
• Do not plug other appliances into the same outlet, it can result in the risk of electric shock.
• Do not disassemble or modify the appliance or the power cord, it can result in the risk of
electric shock or fire. All other services should be referred to a qualified technician.
• Do not place the power cord or appliance near a heater, radiator, or other heat source.
It can result in the risk of electric shock or fire.
• This unit is equipped with a cord that has a earthed wire connected to an earthed pin or
grounding tab. The plug must be plugged into a socket that is properly installed and earthed.
Do not under any circumstances cut or remove the earthed pin or grounding tab from this plug.
• The unit should be used or store in such a way that it is protected from moisture e.g.
condensation, splashed water, etc. Unplug unit immediately if this occurs.
• Always transport your appliance in a vertical position and place on a stable, level surface during
use. If the unit is transported laying on its side, stand the unit upright and unplugged for
six (6) hours before use.
• Always use the switch on the control panel or remote controller to turn the unit off, and do not
start or stop operation by plugging in or unplugging the power cord. It can result in the risk
of electric shock.
• Do not touch the buttons on the control panel with wet or damp fingers.
• Do not use hazardous chemicals to clean or come into contact with the unit. To prevent
damage to the surface finish, use only a soft cloth to clean the appliance. Do not use wax,
thinner, or a strong detergent. Do not use the unit in the presence of inflammable substance
or vapour such as alcohol, insecticides, gasoline, etc.
• If the appliance is making unusual sounds or is emitting smoke or an unusual odor,
unplug it immediately.
• Do not clean the unit with water. Water can enter the unit and damage the insulation, creating
a shock hazard. If water enters the unit, unplug it immediately and contact Customer Service.
• Utilize two or more people to lift and install the unit.
• Always grasp the plug when plugging in or unplugging the appliance. Never unplug by pulling
on the cord, it can result in the risk of electrical shock and damage.
• Install the appliance on a sturdy, level floor capable of supporting up to 110 lb (50 kg).
Installation on a weak or unlevel floor can result in the risk of property damage
and personal injury.
ELECTRICAL CONNECTIONS
Before plugging the appliance into the mains socket, check that:
• The mains power supply corresponds to the value indicated on the rating plate on the back
of the appliance.
• The power socket and electrical circuit are adequate for the appliance.
• The mains socket should match the plug on the appliance. If that is not the case,
have the socket replaced.
• The mains socket is adequately earthed. Failure to follow these important safety instructions
absolves the manufacturer of all liability.
WARNING
• This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• If the SUPPLY CORD is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
• The appliance should be installed in accordance with national wiring regulations.
• Do not use any means to accelerate the defrosting process or to clean, other than those
recommended by the manufacturer.
• The appliance should be stored in a room that does not contain continuously operating ignition
sources (for example: open flames, an operating gas appliance or an operating electric heater.
• Do not pierce or burn.
• Be aware that refrigerants may not contain an odour.
• If you suspect a leak or the unit is not performing as expected, immediately stop using the unit
and contact Customer Service
• The handling, installation, storage, servicing and disposal must comply with the provisions
of gas-related national laws and regulations, and also national wiring regulation.
• It is necessary to clear away the refrigerant in the system when maintaining or scrapping
an appliance.
• Ventilated area (open doors and Windows)
• Ensure that the working area is open or well ventilated before turning on the system or
performing hot work. Ventilation should be maintained during operation. Ventilation quickly
displaces safely diluted leaked refrigerant into the atmosphere.
• Flammable refrigerant R32/R290 is used within appliance. Please follow the instructions
carefully to handle, install, clean, and service the appliance to avoid damage or hazard.
Do not dispose of appliance in regular trash. Contact qualified agency for proper disposal.
• Servicing shall be performed only as recommended by the manufacturer.
• Only individuals authorized by an accredited organization certifying their competence
to handle refrigerants in compliance with industry legislation should work
on the refrigerant circuit.
• All working procedure that affects safety means shall only be carried
by competent persons.
• Repair must be performed based on the recommendations from the manufacturer.
Maintenance and repair that requires the assistance of other qualified personnel must
be performed under the supervision of specialists in the use of flammable refrigerants.
important safety instructions
save these instructions
For Household Use Only
WARNING
IMPORTANT NOTE: Read this manual
carefully before installing or operating your
new air conditioning unit. Keep this manual
for future reference.
A2L
CAUTION: Risk of fire/ flammable materials
Loading ...
Loading ...
Loading ...