Kenmore 11094836202 Official Dryer

User Manual - Page 5

For 11094836202.

PDF File Manual, 44 pages, Download pdf file

Loading ...
Loading ...
Loading ...
INSTALLATION INSTRUCTIONS
Check that you have everything necessary for correct installation.
Proper installation is your responsibility.
8in. orl0in, pipewrench Knife
8 in. or 10 in. adjustable Safety glasses
wrench (for gas
connections) Duct tape
Flat-blade screwdriver Pipe-joint compound
resistant to L.R gas
Adjustable wrench that Caulking gun and
opens to 1 in. (2.54 cm) compound (for installing
or hex-head socket
wrench (for adjusting new exhaust vent)
dryer feet) Gloves
Level Pliers
_/4in. nut driver or socket
wrench
Parts supplied
Remove parts package from dryer drum. Check that all parts
were included.
4 Leveling legs
NOTE: Do not use leveling legs if installing the dryer on a
pedestal.
Parts needed
Check local codes and with gas supplier. Check existing gas
supply, electrical supply and venting. Read "Electrical
Requirements," "Gas Supply Requirements" and "Venting
Requirements" before purchasing parts.
For close-clearance installations between 31.5 in. (80.01 cm)
and 37 in. (93.96 cm), see "Plan Vent System" section for
venting requirements.
I< 87,, >1
(93.98 Cm)
Mobile home installations require special parts (listed following)
available for purchase from your local Sears store or Sears
Service Center. For further information, please call
1-800-4-MY-HOME _(1-800-469-4663).
Mobile Home Installation Kit. Ask for Part Number 346764.
Metal exhaust system hardware.
Are you placing the dryer on a pedestal? You can purchase a
pedestal separately for this dryer. This pedeNal will add about
]4 in. (35.56 cm) to the height of your unit for a total height of
approximately 52 in. (f 32.O6 cm).
Optionalpedestal
The pedestal is available in three colors
White - Part Number 42842
Biscuit - Part Number 42844
Graphite - Part Number 42846
To order, call your local Sears store. For further information,
please call t-800-4-M¥-HOME _ (1-800-469-4663).
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Place dryer at least 18 inches (46 cm) above the
floor for a garage installation.
Failure to do so can result in death, explosion,
or fire.
You will need
A location that allows for proper exhaust installation. A gas
dryer must be exhausted to the outdoors. See "Venting
Requirements."
A grounded electrical outlet located within 2 ft (61 cm) of
either side of the dryer. See "Electrical Requirements."
A sturdy floor to support the total dryer weight of 200 Ibs
(96.7 kg). The combined weight of a companion appliance
should also be considered.
A level floor with a maximum slope of 1 in. (2.5 cm) under
entire dryer. (If slope is greater than 1 in. [2.5 cm], install
Extended Dryer Feet Kit, Part No. 279816.) Clothes may not
tumble properly and automatic sensor cycles may not
operate correctly if dryer is not level.
Loading ...
Loading ...
Loading ...