Loading ...
Loading ...
Loading ...
TOREPLACEHEADUGHTBULB
• Raisehood.
• Pull bulb holder out of the hole in the
backside of the gdll.
• Replace bulb inholder and push bulb
holder securely back into the hole in the
backside of the gdll.
• Close hood.
INTERLOCKS AND RELAYS
Loose or damaged widng may cause your
tractor to run poorly,stop running, or pre-
vent it from starting.
• Check wiring. See electricalwiring dia-
gram in theRepair Parts section.
TO REPLACE FUSE
Replace with 30 amp automotive-type
plug-in fuse. The fuse holder is located
behind the dash.
formed by an authorized engine manufac-
turer's service outlet.
TO REMOVE HOOD AND GRILL
ASSEMBLY
• Raise hood.
• Unsnap headlight wire connector.
Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of
tractor.
• To replace, reverse above procedure.
ENGINE
Hood
Headlight
Wire
Connector
Maintenance, repair, or replacement of the
emission controldevices and systems,
which are being done at the customers
expense, may be performed by any non-
road engine repair establishment or indi-
vidual. Warranty repairs must be per-
formed by an authorized engine manufac-
turer's service outlet.
TO ADJUST THROTTLE CONTROL
CABLE
The throttlecontrol has been preset at the
factory and adjustment should not be nec-
essary. Check adjustment as described
below before loosening cable. If adjust-
ment is necessary, proceed as follows:
• With engine not running, move throttle
control lever to fast position.
• Check that speed control lever is
against stop screw. If it is not, loosen
casing clamp screw and pull throttle
cable untillever is against screw.
Tighten clamp screw securely.
TO ADJUST CHOKE CONTROL
Idle Fuel
Adjusting Idle Speed
Needle Screw
Control
Cable
sto_
Clamp Screw Choke Contro_Cable
The choke control has been preset at the
factory and adjustment should not be nec-
essary, check adjustment as described
below before loosening cable. If adjust-
ment is necessary, proceed as follows:
• With engine not running, move choke
control (located on dash panel) to full
choke position.
• Remove air cleaner cover, filter and car-
tddge plate to expose carburetor choke
(See =AIR FILTER _ in the Customer Re-
sponsibilities section of this manual).
• Choke should be closed. If it is not,
loosen casing clamp screw and move
choke cable until choke is completely
closed. Tighten casing clamp screw se-
curely.
• Reassemble air cleaner.
Closed for Full
29
Loading ...
Loading ...
Loading ...