Loading ...
Loading ...
Loading ...
16
FINAL INSTALLATION
Install bulbs (G).
WARNING: When replacing bulbs, allow bulbs
and shade to cool down before touching.
7.
8.
Remove finial (M), finial plate (L), hex nut (K),
flat washer (J) and rubber washer (I) from
threaded rod at bottom of light kit fitter (H).
Align hole in center of shade (F) with threaded
rod on light kit fitter (H), allowing pull chains to
come through corresponding holes in shade
(F). Push up gently on shade (F) until threaded
rod comes through hole. (Be sure fan pull chain
does not rub against bulbs during fan
operation.) Replace rubber washer (I) and flat
washer (J) and then secure shade (F) with hex
nut (K).
Align hole in center of finial plate (L) with
threaded rod, allowing pull chain from light to
come through hole in finial plate (L) and push
up. Thread center pull chain through hole in
finial (M) and secure finial plate (L) by
tightening finial (M).
NOTE: Do NOT overtighten hex nut (K) and
finial (M) as shade (F) may crack or break.
7
G
J
K
F
I
L
G
Pull Chain
Threaded
Rod
8
M
H
Loading ...
Loading ...
Loading ...