Loading ...
Loading ...
Loading ...
37
To light the rotisserie burner before cooking
The location of the rotisserie burner makes it more susceptible to strong wind conditions, more so
than the protected grill burners. For this reason you should avoid operating the rotisserie during
windy conditions. As an added safety feature we’ve equipped the burner with an automatic safety
valve which will not allow gas to flow to the rotisserie burner unless the following conditions are
present with the knob on:
1 The safety valve button is pressed, and held down.
2 The safety valve thermocouple has been sufficientlyheated to keep safety valve open.
Note: the Grill Igniter will glow orange, but there will be no clicking sound during ignition.
Push in and hold the selected burner knob for two seconds. Verify that the Grill ignitor is glowing.
Turn the burner knob to “HI” position. Then press and hold the safety valve button in for 10 seconds
or until the burner remains lit. Once lit, turn control knob to desired setting. If burner does not light,
turn knob "OFF" and wait five minutes before trying again so any accumulated gas may dissipate.
y If relighting a hot burner, wait five minutes.
y Never leave the control knob on if rotisserie is not in use.
y Never light the grill or sear burners under the rotisserie while the rear rotisserie burner is lit.
IMPORTANT!
Electrical Earthing Instructions: this appliance (rotisserie motor) is equipped with a three-prong
(earthing) plug for your protection against shock hazard and should be plugged directly into a
properly earthed three-prong receptacle or a three-prong earthed extension cord rated for the power
of the rotisserie motor and approved for outdoor use. Do not cut or remove the earthing prong from
this plug. Use only a residual current device (RCD) protected circuit.
The rotisserie motor must be electrically earthed in accordance with local codes. The rotisserie
motor should be supplied through a residual current device (RCD) having a rated residual operating
current not exceeding 30 mA. Keep the rotisserie motor electric cord away from the heated surfaces
of the grill. When not in use, remove and store the motor in a dry location. To protect against elec-
tric shock, do not immerse the cord or plug in water or other liquid. Unplug rotisserie unit from the
outlet when not in use and before cleaning. Allow the rotisserie to cool before putting on or taking
off parts.
Manual lighting
To manually light the rotisserie, place a butane lighter
near the tip of the thermocouple. Push in and turn the
control knob to “HI”. Hold the safety valve button in for
10 seconds or until the burner remains lit. Once lit, turn
control knob to desired setting. If the burner does not
light, release the safety valve button and turn the control
knob to “OFF” and wait 5 minutes before trying again.
IMPORTANT!
Keep hands and face away from front of burner! Stand to
the side when lighting. Once lit move hand away quickly.
FIG. 31
USING THE ROTISSERIE
Loading ...
Loading ...
Loading ...