Loading ...
Loading ...
SETUP & OPERATION
STEP 1. INSTALL BATTERIES
1.
Open the safe door. (Safe shipped with door unlocked).
2.
Remove battery compartment (A) cover on inside door.
3.
Insert 4 “AA” batteries (included).
4.
Replace the battery cover.
5.
Do not close door before testing digital lock.
STEP 2. TEST DIGITAL LOCK
LOCK SAFE
1.
Enter the factory preset pass code: “1”-“5”–“9”
2.
Immediately after entering the code, press the “lock” key.
3.
Lock bolts should extend into the locked position.
UNLOCK SAFE
1.
Enter the factory preset pass code: “1”-“5”–“9”
2.
Immediately after entering the code, press the “lock” key.
3.
Lock bolts should recede into the unlocked position.
STEP 3. LOCK SAFE WITH A NEW PASS CODE
1.
Close the safe door and hold it closed.
2.
Enter a new (3-6 digit) pass code followed by “lock”.
3.
Motorized lock will return door to closed position.
4.
The LED will display “CLOSED” for 3 seconds followed
by the active code entered as a reminder.
NOTE: The lock design allows for a new user code each time that the safe is locked
STEP 4. OPEN SAFE WITH NEW PASS CODE
1.
To open safe enter the new pass code that was used
to lock the safe followed by “lock”.
2.
The motorized lock will unlock the door and the LED
will display “OPENED”.
PRIVACY MODE:
To prevent the LED displaying the pass code entered, press “clear” prior to entering a code.
LOCK SOUND:
To turn “beep” sound On or Off, press the “CLEAR” button twice.
If you press a wrong key while entering your code, you
may press “clear” to reset prior to pressing, “lock”. If you
have entered the wrong code followed by “lock”, the
LED panel will display “ERROR”
If a wrong code is entered 3 times in a row, the digital
keypad will begin a five-minute lockout period. During
this period the LED will display “HOLD05” and the
keypad will become disabled. Once the lockout period
has expired, the safe can be unlocked using the active
code.
You may use the override key to open safe, but keypad will complete the full lockout period.
If the active code is unavailable or your keypad fails due to dead batteries, etc., you may
open the safe using the Override access key.
You may check the battery power at any time by pressing the “lock” key just once.
The LED display will show one of the following messages:
Battery power is good
Battery power is low and batteries should be replaced
To replace the batteries please follow the instructions in STEP 2. in the SETUP section.
It is NOT RECOMMENDED to use Non-alkaline or rechargeable batteries.
NOTE: The active code will not be erased if the batteries become weak or are removed.
1.
Insert Override key and turn to right (open position).
2.
With the key in the open position press “clear” on your keypad.
3.
Turn the key to left (lock) position and remove it from lock.
4.
The safe may be opened by pressing any 3-6 digit code followed by “lock”.
5.
You may now enter any new 3-6 digit code and return to normal operation.
Loading ...
Loading ...
Loading ...