Loading ...
Loading ...
Loading ...
12
1
assembly continued…
3.2
3.3
3.4
Pull the chain brake/guard towards the front handle until you hear an audible
click to check the chain brake is disengaged (1).
Loosen the nuts and remove the chain sprocket cover (2).
Install the bumper spike to the power unit using the 2 hex screws provided in
the tool kit (3).
3.5
Install the guide bar over the 2 studs and whilst wearing thick protective gloves,
place the chain round the rear sprocket and the guide bar (4).
NOTE Pay attention to the correct direction of the saw chain.
This is indicated on the top of the guide bar.
3.6
Adjust the position of the chain tensioner stud on the chain cover moving it back
towards the lower adjustment hole on the guide bar. (5).
2
3
4
5
Loading ...
Loading ...
Loading ...