Loading ...
Loading ...
Loading ...
mechanism has a total adjustment
range of 7/8" (23 mm). Each cast indica-
tor mark next to coarse adjustment
lever is equal to 1/8"
To prevent damage
to tool, avoid wedg-
ing the coarse adjustment lever
against the (A) or (B) portion of the
housing as shown in figure 3.
The indicator ring may be reset to zero
without moving the fine adjustment
knob, to allow the user to begin the
adjustment from any reference point
desired.
▼ TO CLAMP MOTOR
When final coarse and fine adjustments
have been made, fasten the base clamp
lever to secure adjustments. (If addi-
tional clamping force is desired: using a
10 mm wrench, rotate clamp nut clock-
wise SLIGHTLY (1/8 turn or less), then
test clamp. Do not over-tighten.)
5
Fig. 4
Fine
Adjustment
Knob
Hex
Wrench
Operating Instructions
2610052946_RA1165 4/9/19 1:42 PM Page 5
Loading ...
Loading ...
Loading ...