Loading ...
Loading ...
Loading ...
The appliance uses LED lighting strips powered by a low voltage transformer. If
replacement is required, please order genuine replacement parts from Rhino.
3.0 MAINTENANCE
3.1 Lighting
Please observe all of the safety warnings, precautions and instructions set out in Section 1.
The interior walls and shelves should be cleaned and sanitised on a regular basis so as
to ensure hygiene regulations are met. Please do not use splashing, dripping, jetting
or running water. Do not use steam. Only a damp or wet cloth should be used in
conjunction with appropriate cleaning materials for the task in hand. Always follow the
3.2 Cleaning the interior and exterior
The condenser is located at the rear of the appliance behind the compressor compartment
cover. The function of the condenser is to dissipate the heat that has been extracted
kept clean and free of dust at all times.
3.3 Cleaning the Condenser
This appliance has a low maintenance condenser that is less prone to blockage than
other types. However it is still recommended to check that it is clean and dust free at
least every three months. Please adopt the following procedure or go to
www.cleanme.eu for a demonstration:
enclosure. Unplug from the mains power supply.
Step 2: Looking at the back of the appliance, remove the screws from the rear
compartment cover.
Step 3: Locate the condenser and examine it for dust or debris.
Step 4: Clean the condenser using the nozzle of a vacuum cleaner or a soft brush.
Dust that is removed must be cleared away. The condenser is a delicate
component and must be treated with great care and respect. Be careful of
use water in this area.
Note: If the condenser has been contaminated with grease or fat, then a skilled and
competent refrigeration specialist will be required to do the cleaning. Do not use the
cabinet or plug it back in until the cleaning has been done professionally by a skilled
Step 5: Replace the cover and screws and plug back in to the mains power supply.
7
Loading ...