Loading ...
Loading ...
Loading ...
About the automatic icemaker.
A newly installed refrigerator may take 12 to 24 hours to begin making ice.
On dispenser models, to Automatic Icemaker
access ice or reach the
power switch:
o Lift the bin, then pull it
forward until the bin stops.
O Lower the bin to access ice
or reach the power switch.
NOTE"In order to take fulladvantage
of thetilt-out icebin, only storeitems
on theshelf belowthe ice bin that
are no tallerthan thelowestpoint
on thebin.
Lift the bin, then pull it
_ forward until the bin stops,
Lift and pul! forward again
_ to remove the bin.
The icemaker will produce _ven cubes
per cyvle--apwoximalely 100-130 cubes
in a 24-hour period, depending on freezer
coInparlment temperature, rooill
temperature, number of door openings
and other use conditions.
If tile refrigerator is operated betbre tile
water COIlnectioIl is made to tile icemaker,
set file power switch in tile 0 (off] position.
_¢VtleIl tile refrigerator has been connected
u) tile water supply, set tile ix)wet switch to
tile I (on) position.
Tile icemaker will fill witil water when it
cools to 15°F (-10°(;). A newly installed
refrigerator may take 12 to 24 hours to begin
making ice cul_.
You will hear a buzzing sound each time
ltle icemaker fills with water.
Throw a_ay the first few batches of ice to
allow tile water line Ix) clear.
Be sure nothing interfieres with 1tie sweep
of tile feeler ann.
_Then tile bin fills to tile level of tile fi_eler
arm, tile icemaker will stop pro&icing
ice. It is normal for several cubes to be
joined together.
If ice is not u_d frequently, old ice cubes
will become cloudy, taste stale and shrink.
Special notes about dispenser models:
/;)_Dispenser Inodels have a tih-out ice bin.
The bin can be tilled out as shown in
tile illustrations, and it will hold ilseff
up while ylm take ice out or mm the
icemaker power switch on and off"
Be sure m put tile bin back in place
befbre closing tile &)or.
@ To restore your ice level from an empty
bucket stage, the following steps are
recommended:
12 hours after tile first batch of ice
has fMlen inlo tile bin, dispense
3 to 4 cubes.
After an additional 6 hours, dispense
3 to 4 cubes again.
These steps will restore your ice level
in tile shortest amount of time.
i_i}!;¸{_ii_ _;ii;{{¸i! !}!ii} }i ¸{ i }!{__)}:iil;iii
NOTE.."In homes with lower-than-averagewater
pressure,you may hearthe icemaker cycle multiple
tines when maklhgone batchof ice.
Removing Ice Bin (dispenser models)
CAUTION: The ice bin is heavy when full
Set die power swi/ch to tile 0 (Off)position
befbre removing die biIl.
When replacing the bin, be sure to press it
firmly into place, flit does not go all tile
way back, relnove it and rotate Ihe drive
mechanism 1/4 ram. Then push tile bin
back again.
12
Dispenser Models only
Loading ...
Loading ...
Loading ...