Loading ...
Loading ...
Loading ...
7
EN
1
JACK/FEMALE XLR INPUTS (BAL/UNBAL) The system accept jack or XLR
input connectors� These balanced inputs can be used to connect balanced or
unbalanced microphones or audio sources at line level� The balanced connector is
connected in parallel and can be used to send the audio signal to other amplified
speakers, recorders or supplementary amplifiers�
2
LIMITER LED The amplifier has a built in limiter circuit to prevent clipping of
the amplifiers or overdriving the transducers� When the soft clipping circuit is active
the LED blinks RED� It is okay if the limit LED blinks occasionally� If the LED blinks
frequently or lights continuously, turn down the signal level�
3
SIGNAL LED The signal indicator lights green if there is signal present on the
main input�
4
POWER STATUS LED This green led is ON when the speaker is connected to
the mains power source and the ON/OFF switch is in ON position�
5
MALE XLR SIGNAL OUTPUT The output XLR connector provides a loop
trough for speakers daisy chaining�
6
VOLUME CONTROL Adjust the amplifier volume� This control does not affect
the “Link” - “Input - Link” output level�
7
FLAT/BOOST SWITCH Set the flat or boost equalization� “Boost” equalization
is a loudness recommended for background music applications, when the system
plays at a low level� For all other applications “Flat” equalisation is recommended�
8
INPUT SENSITIVITY SWITCH Position the switch in LINE to use a line level
source (0 dB) or MIC to use a microphone source�
9
IEC AC SOCKET The IEC AC socket connect the power cord to the socket�
10
FUSE CARRIER Mains fuse housing�
11
POWER MAINS SWITCH The power switch turns the AC power ON and OFF�
WARNING! CAUTION! Loudspeaker connections should be
only made by qualified and experienced personnel having the technical
know-how or enough specific instructions (to ensure that connections are
made correctly) in order to prevent any electrical danger.
To prevent any risk of electric shock, do not connect loudspeakers when
the amplifier is switched on.
Before turning the system on, check all connections and make sure there
are no accidental short circuits.
The entire sound system shall be designed and installed in compliance
with the current local laws and regulations regarding electrical systems.
3. REAR PANEL
8
9
10
7
11
2
4
3
1
6
1
5
Loading ...
Loading ...
Loading ...