Loading ...
Loading ...
Loading ...
Operating Your Heater
WARNING: In order to avoid overheating or fire, DO NOT COVER the heater.
WARNING: Do not use this heater with a programmer, separate timer, remote-
control system or any other device that switches the heater on automatically - as a
fire risk exists if the heater is covered or positioned incorrectly.
WARNING: Never leave this heater unattended when in use.
NOTE: When the appliance is turned on for the first time, it may release a slight
odour or smoke. This odour or smoke is a normal occurrence caused by the initial
heating of the internal heating elements and should not occur again.
IMPORTANT NOTE:
Goldair bathroom heaters have multiple operating modes:
Heat Control – Hot Air – 2000W
Use the pull cord to start the heater and again to turn the heater off.
Automatic Step-down Heat – Warm Air – 1000W
When the room reaches a preset temperature, the heater will automatically step-
down and reduce the heat output to save power. If the room cools down, the heater
will automatically resume the 2000W setting.
Overheat Protection – Cold Air
The heater will switch off the heating element in the event of over heating, the fan
will continue to operate. The heater will automatically reset and resume heating
when it has cooled down.
If the heater is blowing cold air, power it off and leave it for
1-2 hrs to allow the safety devices to cool down and reset.
Then restart your heater and if;
A) it blows warm or hot air, continue to use the heater.
B) it still blows cold air, then the one shot thermal safety
device has activated. You will need to contact CDB
customer services team with a photo of your installation
and we will be in touch with further instructions. Scan the
below QR-Code to be directed to our ‘contact us’ website
page.
Loading ...
Loading ...
Loading ...