Loading ...
Loading ...
Loading ...
5. Observe the headlight aim on the wall. The most intense part of the headlight
beam should be 5 cm below the mark on the wall
w
. Include rider weight on
the seat when measuring.
6. If adjustment is needed, the adjustment screw
q
is located on the right side
of the headlight pod. To adjust the beam, loosen the screw. Adjust the
headlamp to the desired position, then tighten the screw.
LOW BEAM ADJUSTMENT
To adjust the front headlights, do the following:
1. Place the vehicle on a level surface with the headlight approximately 23 ft (7
m) from a wall.
NOTICE
Rider weight must be included on the seat while performing this procedure.
2. Place the transmission in PARK.
3. Measure the distance from the floor to the center of the headlight and make a
mark on the wall at the same height.
4. Turn ignition ON and switch the headlight to low beam.
5. Observe the headlight aim on the wall. The horizontal line, separating the
lit-zone from the unlit-zone, should be aimed 8 in (20 cm) below the mark
placed on the wall in step 3.
132
MAINTENANCE
Loading ...
Loading ...
Loading ...