Loading ...
Loading ...
Loading ...
81
traffic signal, a minor traffic accident
where no one appears injured or a
vehicle. you know to be stolen, call
roadside assistance or other special
non-emergency wireless number.
For more information, please call to 888-
901-SAFE, or visit our website www.ctia.org.
Consumer Information on SAR (Specific
Absorption Rate)
This Model Phone Meets the
Government’s Requirements for Exposure
to Radio Waves.
Your wireless phone is a radio transmitter
and receiver. It is designed and
manufactured not to exceed the emission
limits for exposure to radiofrequency (RF)
energy set by the Federal Communications
Commission (FCC) of the U.S. Government.
These FCC exposure limits are derived
from the recommendations of two expert
organizations, the National Counsel on
Radiation Protection and Measurement
(NCRP) and the Institute of Electrical and
Electronics Engineers (IEEE). In both cases,
the recommendations were developed
by scientific and engineering experts
drawn from industry, government, and
academia after extensive reviews of the
scientific literature related to the biological
effects of RF energy. The exposure limit for
wireless mobile phones employs a unit
of measurement known as the Specific
Absorption Rate, or SAR. The SAR is a
measure of the rate of absorption of RF
energy by the human body expressed
in units of watts per kilogram (W/kg).
The FCC requires wireless phones to
comply with a safety limit of 1.6 watts per
kilogram (1.6 W/kg). The FCC exposure
limit incorporates a substantial margin
of safety to give additional protection
to the public and to account for any
variations in measurements. Tests for SAR
are conducted using standard operating
positions specified by the FCC with the
phone transmitting at its highest certified
power level in all tested frequency bands.
Although SAR is determined at the highest
certified power level, the actual SAR level
of the phone while operating can be well
below the maximum value. Because the
phone is designed to operate at multiple
power levels to use only the power required
to reach the network, in general, the closer
you are to a wireless base station antenna,
the lower the power output.
Loading ...
Loading ...
Loading ...