Loading ...
Loading ...
Loading ...
To disassemble the two-piece shaft
1. Turn the knob 3 turns or more to loosen the
coupling.
2. Push and hold the button (C).
3. Hold tight in the end of the shaft that the motor is
attached to.
4. Pull the attachment out of the coupling.
C
To install the harness support hook
1. Install the harness support hook between the loop
handle and the throttle handle.
Note: Do not put the support hook on the decal.
2. Adjust the ring to make the product balanced, and
easy to use.
To adjust the harness
1. Put on the harness.
2. Attach the harness to the harness support hook.
3. Adjust the length of the harness until the harness
support hook is in level with your right hip.
Operation
Introduction
WARNING: Read and understand the
safety chapter before you use the product.
To connect the battery to the product
WARNING: Only use Husqvarna
original batteries with the product.
1. Make sure that the battery is fully charged.
2. Push the battery into the battery holder of the
product. The battery locks into position when you
hear a click.
CAUTION: If the battery does not
move easily into the battery holder, the
battery is not installed correctly. This can
cause damage to the product.
3. Make sure that the battery is installed correctly.
1846 - 003 - 24.02.2023 11
Loading ...
Loading ...
Loading ...