Ryobi PBLMS01B ONE+ HP 18V Brushless Cordless 10 in. Sliding Compound Miter Saw Tool Only

OPERATOR’S MANUAL - Page 14

For PBLMS01B. Also, The document are for others Ryobi models: PBLMS01

PDF File Manual, 104 pages, Read Online | Download pdf file

PBLMS01B photo
Loading ...
Loading ...
Loading ...
14 − English
Fig. 10
LOCK
PIN
“D”
HANDLE
Fig. 9
DEPTH
CONTROL KNOB
DEPTH STOP
ASSEMBLY
USING THE DEPTH STOP
See Figure 9.
When used, the depth stop limits the downward travel of
the blade when cutting dadoes and other non-through cuts.
To use the depth stop:
Remove the battery.
If the saw is in storage or transport position, unlock the
saw arm.
Rotate the depth stop away from the motor housing.
With the end of the depth control knob touching the depth
stop, adjust the depth control knob by turning the knob
until the desired depth of cut is attained.
A wooden spacer of at least 2 1/2 inches must be placed
between the workpiece and the fence for a consistent
depth of cut in the workpiece. Use the work clamp to
clamp the spacer and another suitable clamp to clamp
the workpiece. Make the slide cut at the desired depth.
See Figures 35 and 36.
Rotate the depth stop back towards the motor housing
for normal through cuts.
NOTE: The depth stop must be moved toward the motor
housing before locking/unlocking the saw arm.
LOCKING/UNLOCKING THE SAW ARM
See Figure 10.
When locking and unlocking the saw arm, it is not necessary
to loosen the depth control knob.
To unlock and raise the saw arm:
Firmly grasp the “D” handle and apply downward pres-
sure while at the same time pulling the lock pin out and
away from the saw housing.
Release the lock pin and slowly raise the saw arm.
To lock the saw arm:
Firmly grasp the “D” handle and apply downward pressure
while at the same time pushing the lock pin in and toward
the saw housing.
Release the lock pin allowing it to lock the saw into place.
Loading ...
Loading ...
Loading ...