Loading ...
2
5*)
2
6.
7.
Locate the motor (11) and insert into the inner tube (8).
Align the motor hole (11) to the hole of the inner tube (8), insert two screws (9)
and washers(10) and tighen them
5
8
6
, then (2) into the
Align the stand pole (5) holes to the holes of the base frame (1).
bottom of the stand pole (6).
4
clips are completely in locking position
screws (4) and washers (3) from the base frame (1).
(6)
insert on the inner tube (8).
motor holes (11) to the holes of the inner tube (8), insert two screws (9)
before operation.
NOTE; Keep the hexagonal head screw driver (20) for future use.
CAUTION: Do not alter the angle of the blades.
Carefully slide the rear grille guard (12) over the bolts, making sure to align the
loops in the center of the rear grille with the threaded posts on the fan motor.
Remove the 4 nuts (16), spring washers (15) and flat washers (14) from the
bolts around the motor front cover.
Remove and dispose of the black bar that is securing the fan blade to the rear
grille.
Secure FIRMLY with the flat washers (14), spring washers (15) and nuts (16)
removed in Step 1.
Carefully slide the blade assembly (18) over the shaft and align set screw (17)
with the slot on the motor shaft.
Tighten the blade assembly (18) with the set screw (17).
1.
2.
3.
4.
5.
6.
STAND POLE & MOTOR ASSEMBLY INSTRUCTIONS
Loading ...
Loading ...