Dewalt DXGP210 27 cc 2-Cycle 10 in. Gas Pole Saw with Attachment Capability

Operator’s Manual - Page 28

For DXGP210.

PDF File Manual, 136 pages, Read Online | Download pdf file

DXGP210 photo
Loading ...
Loading ...
Loading ...
28
OPERATION
WARNING: Always check the chain tension and adjust as necessary before beginning
operation. Refer to Adjusting the Chain Tension in the Maintenance section.
WARNING: Make sure the chain oil reservoir is full before operation. Check the oil level
constantly so that it does not drop below half full. Make sure the chain oil adjustment screw
is set appropriately. Refer to Setting the Chain Oil Adjustment Screw in the Maintenance
section. The saw chain must be continuously coated with oil to function properly.
WARNING: Always wear appropriate eye, hearing, hand, foot and body protection to
reduce the risk of injury when operating this unit. Wear head protection. Use a full face shield
when needed. Refer to the Safety section for appropriate safety equipment information.
WARNING: Do not use a pole saw to fell a tree. Do not use a pole saw to limb or buck
a fallen tree. Use a chain saw for these applications.
WARNING: Do not operate the unit in a tree or on a ladder unless specically trained
to do so.
WARNING: Falling branches can cause serious injury. Always wear appropriate head
protection. Plan an escape route away from falling limbs. Do not stand, or position any
body parts, directly below the branch being cut.
HOLDING THE UNIT
Always grip the unit rmly with both hands when the unit is running.
Hold the shaft grip with the right hand. Keep the right arm slightly bent.
Hold the handle with the left hand. Keep the left arm straight.
Hold the unit at waist level.
Stand in a stable position with feet apart and rmly planted.
Do not extend arms above shoulder height. Do not overreach.
When carrying the pole saw from one place to another, hold it at the balance point and keep the
guide bar pointed to the rear.
PREPARING THE WORK AREA
Clear the area of children, bystanders and pets; keep them outside a 50-foot (15 m) radius, at a
minimum. Even then, they are still at risk from thrown objects. Encourage bystanders to wear eye
protection. If you are approached, stop the unit immediately.
Keep the work area clean. Cluttered areas invite injuries. Do not start cutting until the work area is
clear and free from obstructions. Make sure there is secure footing and a planned retreat path from
falling branches.
Do not cut near electrical cables or power lines. Keep at least 50 feet (15 m) away from all power lines.
Use the unit only in daylight or good articial light.
Loading ...
Loading ...
Loading ...