Loading ...
Loading ...
Loading ...
I
3b.
®
®
®
Wiring (pre-wired).
Route wire from wall to Safe-T-Beam _sensors
(Fig. 4-5b).
Splice pre-wiring to shortened sensor wire,
match wire pairs dash-to-dash and
plain-to-plain.
- Trim sensor wire to approximately one foot
(1 ft) from sensor.
- Split and strip ends of sensor wires and
pre-wired wires (Fig. 4-7).
- Splice wires together with (provided)
wire nuts.
Route wire from ceiling to power head Wire Nut
(Fig. 4-5b).
Securely fasten wires where they exit
wall and ceiling as you go.
-Use insulated staples.
-Staples should be snug only.
Insulated
Staple
4. Split and strip ends of sensor wires (Fig. 4-7).
5. Attach Safe-T-Beam ®wire to power head wire
terminal.
• Route Safe-T-Beam _ wires through wire guide.
-Insert wire into terminal holes and lightly press
in the orange locking clips above each terminal
hole. (You can use a pencil or small
screwdriver to comfortably reach in and lightly
press down locking clips.) Insert white wires to
'even' numbered terminal holes and striped
wires into 'odd' terminal holes (Fig. 4-5b).
Locking
i,l_s x_ Terminal
F_/Holes
/ F%q F%q
- Confirm wire lock by lightly tugging on the wire.
The wire should remain in the terminal hole,
• Install rear cover, The rear cover is the same
color as the power head clips and body
(Fig. 4-9).
, Do not install the white (lamp) cover at this time.
Power (
Head
'1 '1
I I
i6S 43 21]or165 43 211
)
Dashed Line = striped wire
Solid Line = white wire
Insert Wire
Wire Into Connector .... "'"
__ Wires
i IlJ_: _=_ _ _ [=_' ' i[ wirer°utinged
Source or Sensor
Source or Sensor ro ec ion rea
Cover clips
8 PNi/ 3642036534, 02/26/2010 REV. 1
Loading ...
Loading ...
Loading ...