Loading ...
Loading ...
Loading ...
ASSEMBLY gNSTRUCTIONS
TOOLS REQUIRED
(1) Adjustable Wrench
(1) 3/8" Open End or Box Wrench
(1) 7/16" Open End or Box Wrench
(1) 1/2" Open End or Box Wrench
(t) 9/16" Open End or Box Wrench
(1) Standard Screwdriver
(1) Pair of Pliers
Refer to carton contents figure on page 2 and figure
1 on page 3 for parts and hardware needed to
assemble sweeper housing_
.
Remove two 5/16" hex lock nuts and 5/16" flat
washers from the middle of the sweeper
housing. Assemble the hitch tongue to the
sweeper housing using two 5/16" x 1-1/2"
carriage bolts with the heads on the inside of
the housing. Secure with the two 5/16" hex
lock nuts and flat washers removed above, See
figure 3, Do Not Tighten At This Time,,
5/16" HEX
LOCK
NUT
5116" x 3!4" CARRIAGE BOLT
,J BRACERd
5/16" FLAT WASHER
SWEEPER HOUSING
FIGURE 4
NOTE
Before assembling the hitch bracket
to the hitch tongue, refer to figure 5
and page 11 to determine which
position is required for your towing
vehicle°
SWEEPER HOUSING
5!16" x 1o112" CARRIAGE BOLT
HITCH TONGUE
5116"
FLAT WASHER
/
5f16'" HEX LOCK NUT
FIGURE 3
.
Attach the brace rod to the square hole in the
sweeper housing, using two 5/16" x 3/4"
carriage bolts (assembled with the heads on the
inside of housing). Two 5/16" flat washers and
5/16" hex lock nuts are assembled outside as
shown. See figures 4 and 5, Do Not Tighten At
This Time.
,
Assemble the hitch bracket to the hitch tongue,,
using 3/8" x 3/4" hex bolt (in front hole) an_
3/8" hex lock nut. See figure 5. Assemble the
brace rod over the back hole in hitch bracket and
secure with large flat washer, 3/8" x 1-1/2" hex
bolt and 3/8" hex lock nut, See figure 5_ Do not
tighten at this time,
3t8" x 3t4"
HEX BOLT
3t8" x 1-1t2"
HEX BOLT ....
HITCH POSITION "B"
SEE PAGE 11
4
i°
FIGURE 5
4
Loading ...
Loading ...
Loading ...