Loading ...
Loading ...
Loading ...
2-12
W
X
3-1
3-7
3-6
AA
BB CC
BB
DD
J
K
L
7
2 – Rack Assembly continued
2-12
(Optional Cable Management Hooks) Fasten
the included cable management hooks
W
to the
vertical rack rails with the included screws
X
.
3 – Optional Casters
Warning: Do not attempt to install casters while equipment is installed in the rack.
Note: Caster installation requires Tripp Lite’s Heavy-Duty Rolling Caster Kit (model SRCASTER, sold separately). The kit includes four casters
and the M6 hardware required to mount the casters to the bottom of the rack.
3-1
Place the empty rack on its side.
3-2
Place a caster
AA
at one of the bottom outside
corners of the rack and line up the holes in the
caster with the holes in the rack.
3-3
Place an M6 washer
BB
over an M6 bolt
CC
and
insert the bolt through one of the caster mounting
holes in the bottom inside corner of the rack and
then through the corresponding mounting hole in
the base of the caster.
3-4
Place an M6 washer
BB
and an M6 nut
DD
over
the end of the M6 bolt
CC
, then tighten 90%.
3-5
Repeat Step 3-3 and Step 3-4 until all four
bolts are in place, then tighten all the nuts and
bolts until the caster is secure.
3-6
Repeat Steps 3-2 through 3-5 until all four
casters are mounted securely.
3-7
Insert an M8 bolt
J
into the hole in each bottom
corner, fasten with an M8 washer
K
and M8 hex
nut
L
and tighten securely. (The M8 hardware is
included with the rack.)
3-8
Place the rack upright on a level surface and
confirm that the rack is stable. If you haven’t
already completed Step 2-10, complete it now.
Loading ...