Loading ...
Loading ...
Loading ...
Page 8
SET UP & USE
OPERATING INSTRUCTIONS
Place the heater on a firm, level surface and plug the unit directly into a 120 V AC
electrical outlet.
NOTE: Only operate heater in upright position.
Setting Temperature using High or Low heat settings
Press the On/Mode/O Button once to set the heater to Low (LO 1000 Watts). The
LO Indicator Light will illuminate.
Press the On/Mode/O Button again to set the heater at the High (HI 1500 Watts)
setting. The HI Indicator Light will illuminate.
The heater will run continuously at these settings.
Setting to Temperature Levels (60 °F - 80 °F)
Continue to press the On/Mode/O Button to cycle through the Temperature
Indicators (60 °F - 80 °F) until your desired temperature is set. The selected
Temperature Indicator Light will illuminate. The heater will cycle on and o to
maintain the selected temperature setting, If the room temperature is too low, either
continue to press the On/Mode/O button to raise the temperature or select the Lo
or Hi Setting for constant heat,
E-Save Setting
Press the E-Save button to activate the Energy Saver Function. The heater will now
cycle between low (at 1000W) and high (at 1500W) heat settings every 15 minutes
to provide heat.
NOTE: The heater thermostat has memory and will remember the previous
temperature setting after the unit has been turned o. If the unit is unplugged,
the heater thermostat will be reset and will no longer remember the previous
temperature setting.
To shut unit o at any time, press and hold the ON/Mode/O Button for 3 seconds
until all indicator lights go OFF.
Loading ...
Loading ...
Loading ...