Loading ...
Loading ...
Loading ...
12.3 BLOWING FEATURE
It can blow sawdust and other debris. Follow the steps below
to use your vac as a blower.
1. Insert the hose into the blowing port.
2. Insert the desired accessory into the end of hose.
3. Start the machine.
12.4 OPERATION TIPS
• The filter must always be in correct position at all times
to avoid leaks and possible damage to the motor.
• When using your machine to pick up fine dust, it will be
necessary for you to empty the collection tank and clean
the filter at more frequent intervals to maintain peak
performance.
• The filter must be dried to avoid possible mildew and
damage to the filter after you use the machine to pick up
liquids.
13 MAINTENANCE
CAUTION
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
CAUTION
Do not use strong solvents or detergents on the plastic
housing or components.
WARNING
Remove the battery pack from the machine or disconnect
the plug from the power source before maintenance.
13.1 EMPTY THE COLLECTION TANK
The collection tank must be emptied when it’s full. Every
now and then the dust collection tank and the filter need to be
cleaned to maintain a high suction power.
1. Disconnect the power cord from the outlet.
2. Turn off the machine.
3. Remove the top cover assembly.
4. Dump the collection tank contents into the proper waste
disposal container.
13.2 CLEAN THE FILTER
NOTE
Allow the filter to dry before you store or picking up debris.
Often clean your filter to maintain peak vac performance.
Clean a dry filter:
• Cleaning should be done outdoors and not in the living
quarters.
• You can use a small brush to clean the dust and debris.
• For thorough cleaning of dry filter with fine dust (no
debris), run water through it as described under "Cleaning
A Wet Filter"
Clean a wet filter:
1. Remove the filter from the machine.
2. Run water through the filter from a hose or spigot.
NOTE
Check the filter for tears or small holes after cleaning. Do
not use a filter with holes or tears in it. Even a small hole
can allow dust to come out of your machine. Replace it
immediately.
14 STORE THE MACHINE
NOTE
Clean the machine before storage.
1. Remove the battery pack.
2. Let the motor cool.
3. Check that there are no loose or damaged components. If
it is necessary, replace the damaged components, tighten
screws and bolts, or speak to a person of an approved
service center.
4. Store the machine in a cool and dry location.
15 TROUBLESHOOTING
Problem Possible cause Solution
The machine
doesn't work.
The switch or mo-
tor is defective.
Speak to service
center.
Dust discharges
from exhaust.
The filter has dam-
age.
Replace the filter.
The filter isn't in-
stalled.
Properly reinstall
the filter.
The filter is not
functional.
Clean or replace
the filter.
The filter clogs.
Clean or replace
the filter.
10
English
EN
Loading ...
Loading ...
Loading ...