Loading ...
Loading ...
Loading ...
Setting Surface Controls (cont'd)
Operating the Triple Surface Element
The cooktop is equipped with a Triple radiant surface element
......-..\
located at the right front cooktop position (Figure 1). Indicator
lights on the control panel at that position are used to indicate
what portions of the Triple radiant element will heat. The
INNER light indicates that only the inner element will heat. The Figure 1
+MIDDLE light indicates that both inner and middle elements
will heat together. The ALL light indicates that all 3 portions of ®<7 ALL
the element will heat. You may switch between all of these ® +MIDDLE
different settings at any time during cooking.
® _b INNER
To Operate the Triple Surface Element:
1. Place correctly sized cookware on the radiant surface element.
,
Touch and hold the _ pad for the Triple element position until Figure 3
a beep is heard. The display will show " - - "
Note: If no further pads are touched within 10 seconds the request to power
the element ON will clear.
3. Select the INNER (See Figure 2), +MIDDLE (See Figure 3) or ALL 3
.. ELEMEJ'-'_'_T
elements (See Figure 4) to heat by pressing tne _ pad once, twice or
three times (Figures 4 & 5 show indicator lights with ALL 3 elements
selected).
4. Touch HI _'_ pad once to turn ON the power level to HI. Touch Lo
(_pad once (See Figure 5).
for Lo
5. Each touch of the HI _-_ or Lo _-_ pad will decrease or increase the
power level from 9.0 through 3.0 by .5 increments. Simmer power levels
between 3.0 and 1.2 will decrease or increase by .2 increments. Lo is the
lowest power level available.
Note: The power level may be adjusted at any time while the element is ON.
6. When cooking has been completed touch the pad once to turn the
element OFF. Each surface element provides a constant amount of heat at
each setting. Irregular glowing effect is depending of the element design and
doesn't affect performance of the element (See Figure 6). A glowing red
surface heating area extending beyond the bottom edge of the cookware
indicates the cookware is too small for the surface heating area. Note: The
Hot Element message will remain displayed on the control panel as long as
the element is still hot and will remain ON until the heating surface area has
cooled sufficiently.
Note: If no element size is chosen when the Triple element is turned ON, the
control will default to the inner coil only. See page 9 for recommended surface
cooking settings.
Note: The Hot Element message will remain displayed on the control panel as
long as the element is still hot and will remain ON until the heating surface area
has cooled sufficiently.
Figure 2
@o ALL
® c_ +MIDDLE
® C.b INNER
Figure 4
HI @÷ ALL
@ _ +MIDDLE
LO @ _ INNER
Figure 5
Figure 6
Radiant surface elements may appear to have cooled after they have been turned off. The glass surface
may still be hot and burns may occur if the glass surface is touched before it has cooled sufficiently.
Do not place aluminum foil or plastic items such as salt and pepper shakers, spoon holders or
plastic wrappings on top of the range when it is in use. These items could melt or ignite. Potholders, towels or
wooden spoons could catch fire if placed too close to the surface elements.
........iii.......
11
Loading ...
Loading ...
Loading ...