Loading ...
Loading ...
Loading ...
12 Eaton Tripp Lite Series SmartPro User Guide 614-40194—Rev 04
Table 6. Rack EBM Installation Steps
A small amount of arcing may occur when connecting
an EBM to the UPS. This is normal and will not harm
personnel. Insert the EBM cable into the UPS battery
connector quickly and firmly.
To increase stability, it is preferable to place the EBM
below the UPS.
1. Fix the rail on the back of the rack.
2. Fix the rail on the front of the rack using the two holes at the
bottom.
3. Fix the ears plate to the UPS.
4. Place the UPS on the rails and fix the ears plate to the top hole of
the rail.
5. Connect the EBM power cable as shown in the picture.
6. Connect the RJ45 battery detection cable of the first EBM between
the EBM and the UPS connector "Batt detection" (11). For any
additional EBM, connect the battery detection cable to the previous
EBM.
Verify that the EBM connections are tight and that adequate bend
radius and strain relief exist for each cable.
33..55 UUPPSS ccoonnnneeccttiioonn
Check that the indications on the name plate located on the back of the UPS correspond to the AC-power
source and the true electrical consumption of the total load.
UPS connection
Loading ...
Loading ...
Loading ...