Turbofan E23M3 Half Size Tray Manual Electric Convection Oven

Installation Operation Manual - Page 10

For E23M3.

PDF File Manual, 17 pages, Read Online | Download pdf file

E23M3 photo
Loading ...
Loading ...
Loading ...
Cleaning and Maintenance
8
Lamp Glass (Not E22M3)
a. With side racks and fan baffle removed, unscrew
lamp glass, anti-clockwise.
b. Remove seal fitted between lamp glass and holder.
c. Clean the lamp glass using a soft cloth with a mild
anti bacterial detergent and a hot water solution.
d. Dry the lamp glass thoroughly with a dry cloth.
e. To refit the lamp glass, screw the glass in clockwise.
Do not over tighten the lamp glass.
Door Seal
a. To remove door seal, pull 1 piece seal forward until
it pulls out of groove around oven. Note way seal is
fitted to oven, with lip facing inwards.
b. Check for wear and damage to door seal and
replace as required.
c. Wash door seal in a sink, take care not to cut or
damage seal.
d. Dry the door seal thoroughly.
e. Refit door seal with lip facing into centre of oven.
f. Press door seal into locating groove in front face of
oven until seal is properly located all around oven.
Oven Interior
Allow the oven interior to cool to approx 50˚C /
120˚F before commencing cleaning.
a. Remove the oven racks and the fan baffle as shown
previously.
b. Clean any build up of grease from the oven interior,
using a mild anti bacterial detergent, a hot water
solution and a soft bristled brush.
c. Dry the oven thoroughly with a soft dry cloth.
d. Clean the oven regularly with a good quality oven
cleaner.
Door Glass Cleaning
Ensure that the oven door is cool before cleaning
the door glass.
a. Open the oven door.
NOTE: Maintain a hold of the door with one hand
whilst cleaning the inner glass, to prevent the
door from closing.
b. Whilst holding the oven door in the open position,
grasp the bottom of the inner glass and pull glass
towards you until the top of the inner glass rises up.
c. Grasp the inner glass by the finger tabs at the top
of the glass and raise the inner glass to the vertical
position.
Unscrew Anti-
Clockwise
Refit Seal with Lip
facing inwards
Pull Seal out of
locating channel
Finger Tabs
Remove Seal
Loading ...
Loading ...
Loading ...