Loading ...
Loading ...
Loading ...
Beforeyoucall forservice...
Troubleshooting -tips
PossibleCauses WhatToDo
Washerdidnotfill to Extremely low war er pressure • Pressthe STARTbuuonagain.
chosenlevel
Inlet hoses are kinked " Straighten hoses.
Water valve screens are • Turn offthe water source and renlove the water connection
stopped up hoses from the upper back ot the washer. Use a brush or
toothpick to (:lean the screens in the machine. Reconnect
the hoses and mrn the water back on.
" 3("
Waterfills anddrains Drain stand pipe is too low Drain stand pipe must be above, ).
at thesametime
PossibleCauses WhatToDo
Washer is noisy Washer is uneven " To level the fi'ont of the washer, a_!just the flont leveling
legs by rotating the individual leg in tile proper direction
fi)r up or down. To level back of washer, lift back of
machine 4" (l I cm) and sel down.
Washer load is " l'ress PAUSEIo stop/lie washer, open/he lid and
unbalanced redisuibu/e/lie h)ad evenly. Close tlle lid and press
START.
Shipping rod is still assembled " To remove shipping rod from washer, pull yellow tag mad
in unit a/lathed rod flom/lie bol/Olll righ/hand side of washer.
Washer is sitting too close " Pull washer aw:ty fiom/lie wall; abou/4" (11 (m)
towall (causes knocking is needed.
during cycle )
Possible Causes What ToDo
Labels onthe exterior Occasionally the adhesive
of the washer will not used on the labels does
peel off cleanly not release cleanly
" Use a hair (hTer set at the lowest heat setting, (firecting
the _firat the label ti)ra short amount of time. This will
release the adhesive easily, '_4thout damaging the surlilce
ofthe washer.
12
Loading ...
Loading ...
Loading ...