Loading ...
Loading ...
Loading ...
8
OPERATING INSTRUCTIONS
INSTRUCTIONS FOR USE
1. Remove the insulating fi lm from the remote control battery
compartment.
2. Ensure the power is turned off.
3. Decide which installation method to use and install the fi replace as
directed.
4. Plug the fi replace directly into a 120V AC electrical outlet.
5. Turn the fi replace on by pressing the power button.
6. Press the heater button to set low or high heat mode.
7. Turn the thermostat dial to set the desired temperature. The fi replace
will remain on until the set temperature is reached and it will then
cycle on and off to maintain the set temperature.
8. Turn the fi replace off by pressing the power button. When the power
is turned off the heating element will stop working immediately but
the fan will continue to run for 30 seconds or until the fi replace has
cooled.
Important
When the heat feature is used for the fi rst time, a slight odor may be
present. This is normal and should not occur again unless the fi replace is
not used for an extended period of time.
It is normal for the fi replace to cycle on and off as it maintains the set
temperature.
For the fi replace to function properly, the set temperature must be higher
than the ambient temperature in the room. If the fi replace does not
seem to be heating, increase the set temperature to engage the heating
element.
Loading ...
Loading ...
Loading ...