Loading ...
Loading ...
Loading ...
44 - INSTALLATION 91477A053/D
edge of the hob before assembly.
In the case of flush mounting, after placing the
adhesive seal (A) on the glass surface and after
positioning and securing the hob, fill the edges
with insulating silicone (B) and wipe off any
excess. If for any reason the hob needs to be
removed, cut the silicone using a cutter before
attempting to remove it (C).
Semi-flush and flush mounting (mm)*
* The image on the left shows the semi-flush opening, while the one on the right shows the flush
opening. Models with copper profiles can only be installed semi-flush.
Mounting
Over built-in oven unit
The clearance between the hob and the kitchen
units or other built-in appliances must be enough
to ensure sufficient ventilation and air discharge.
If installed above an oven, a space must be left
between the bottom of the hob and the top of
the appliance installed below.
Do not use silicone to secure the hob.
This would make it impossible to remove
the hob without damaging it.
P Q X Y F G
Mod. A 38 cm 384 506 310 490 139 65
Mod. B 60 cm 604 514 560 478 - 490 147 145
Mod. C 80 cm - 4 zones 804 514 730 480 145 330
Mod. D 80 cm - 6 zones 804 514 750 - 780 490 145 330
Mod. E 90 cm 904 514 880 490 144 181
1 Electrical connection
1 Opens on bottom
2 Opens on bottom and back
Loading ...