Replacement Faucet Installation Instructions
FIG. 2
FIG. 1
BLACK TUBE
3/8” barb fitting
for the black tube
RED TUBE
1/4” barb fitting
for the red tube
BLUE TUBE
3/8” quick connect
fitting for the blue
tube
faucet
Connect to
electronics
in manifold
The connection from the faucet to your Reverse
Osmosis System may be different with this replace-
ment faucet than the faucet originally supplied with
the Reverse Osmosis System.
Follow the steps below to install the replacement
faucet.
1. Turn off water to the Reverse Osmosis system.
2. Loosen faucet hardware and slide faucet up from
the countertop.
3. Disconnect all tubing connections from faucet and
discard the old faucet and hardware.
4. Snap the o-ring in the groove on the bottom of the
ring and slide the monitor ring onto the faucet
stud. The monitor ring LED wire must be routed
through the sink or countertop hole and through
the spacer, if used. Refer to Fig. 1.
5. Snip off about 1/2” length of tubing from both the
1/4” red tubing and the 3/8” black tubing before
reattaching to the barbs on the new faucet. See
Fig. 2.
6. Work tubing and the faucet stud back down into
the mounting hole in the countertop or sink.
7. On the underside of the sink or countertop, install
the spacer (if included), plastic bushing, flat wash-
er, and hex nut. Refer to Fig. 1. Slide the large
steel washer in place, between the bushing and
spacer (if included). Then, tighten the hex nut
securely. Make sure that the LED wire is in a posi-
tion so that it will not be cut, pinched or kinked
before tightening the faucet assembly.
8. Thread the tubing connector onto the bottom of
the faucet stud. See Fig. 2.
9. Snip off about 1/2” length from the end of the 3/8”
blue tubing from the R.O. Push the end of the blue
tube into the tubing connector. See Fig. 2.
7290143 (Rev. B 3/18/11)
1-1/4” dia. hole
hex nut
washer
bushing
electronics ring
o-ring
steel washer
(large)
spacer
(on select models)
