Loading ...
Loading ...
Loading ...
8
ENGLISH
AC POWERCON RECEPTACLE. RCF TT+ series uses a POWERCON locking 3-pole AC
mains. Always use the specific power cord provided in the package.
POWER MAIN SWITCH. The power switch turns the AC power ON and OFF. Make sure that
the sensitivity is set to +∞ when you turn on the speaker.
GROUND.
LINK XLR OUTPUT. The output XLR male connector provides a loop trough for speakers
daisy chaining.
AC POWERCON LINK RECEPTACLE. Use this receptacle to link one or more units. Always
make sure that the maximum current requirement does not exceed the maximum admitted
POWERCON current. In case of doubt call the closest RCF SERVICE CENTRE.
GROUND.
The XLR connectors use the following AES standard:
PIN 1 = GROUND (SHIELD)
PIN 2 = HOT (+)
PIN 3 = COLD (-)
At this point you can connect the power supply cable and the signal cable, but before
turning on the speaker make sure that the volume control is at the minimum level (even
on the mixer output). It is important that the mixer is already ON before turning on the
speaker. This will avoid damage to the speakers and noisy “bumps” due to turning on parts
on the audio chain. It is a good practice to always turn on speakers at last and turn them
off immediately after the show.
Now you can turn ON the speaker and adjust the volume control to a proper level.
WARNING: Always make sure that the maximum current requirement does not exceed
the maximum admitted POWERCON current. In case of doubt call the closest RCF SERVICE
CENTRE.
TT25-SMA
- 230 VOLT, 50 Hz SETUP: FUSE VALUE T 3.15 A H 250 V
- 115 VOLT, 60 Hz SETUP: FUSE VALUE T 6.3 A H 250 V
VOLTAGE SET UP
(RESERVED TO THE RCF
SERVICE CENTRE)
HOT GND
BAL. XLR
COLD
CONNECTIONS
11
12
13
8
9
10
WARNING
BEFORE TURNING ON
THE SPEAKER
12
11
13
Loading ...
Loading ...
Loading ...