Loading ...
Loading ...
Loading ...
_WARNING: If received assembled,
review all assembly steps to ensure your unit
is properly assembled and all fasteners are
secure.
TUBE ASSEMBLY
Upper Locking Sleeve Assembly
Wires
Lower Locking Sleeve Assembly
1. Align upper tube groove with triangle on
lower locking sleeve assembly. Push
tubes together until they snap into place.
Upper Tube
Groove E_ _:::]
AHgnment Triangte
2. Try to pull tubes back apart. If the tubes do
not come apart, they are properly snapped
into place. If the tubes come apart, repeat
step 1 and push until the tubes snap into
place.
3. Slide upper locking sleeve assembly over
lower locking sleeve assembly and tight-
en by turning clockwise.
4. Ensure locking sleeve assembly and
alignment decals appear as illustrated be-
low.
£A
w_WARNING: The upper and lower
tubes must be snapped together, remain per-
manentty assembled together and the locking
sleeve assembly must be fully tightened be-
fore and during use to avoid serious h_jury to
the operator and/or damage to the unit. DO
NOT attempt to disassemble unit after initial
assembly,
INSTALLATION OF ASSIST HANDLE
1. Loosen and remove wing nut and bolt
from assist handle,
2. Place unit on a flat surface.
3. Firmly push the assist handle over the
tube. To make installation easier, tilt han-
dle toward trigger housing while pushing
down (see illustration).
4. Reinstall bolt in handle. Thread wing nut
onto bolt.
5. Adjust the handle up or down the tube to a
comfortable position; tighten wing nut se-
curely.
,_\ Assist handle
housing \ _"_J'71 _
•_/_,_ _L"Tube
"%
ATTACHING EDGE GUIDE AND
SHIELD
_ WARNING: Theshieldmustbeprop-
erly installed. The shield provides partial
protection from the risk of thrown objects to
the operator and others. Your unit is equipped
with a line limiter blade, which cuts excess
line to the proper length while running. The
line limiter blade (on underside of shield) is
sharp and can cut you.
NOTE: If shield is not properly installed, dam-
age to unit (including motor failure) will result,
1. Insert edge guide into two holes in shield,
NOTE: Edge guide must be positioned on
shield prior to installation on motor housing
(see following illustration),
Edge Guide
Alignment decals
A
At_WARNING: Failure to completely en-
close excess wires in upper tube during assem-
bly of the unit may result in damage to the wires
and/or the unit or serious injury to the operator
including electrocution.
Shield
2. Align the installation arrow on the shield
with the installation arrow on the motor
housing (see illustration below).
4
Loading ...
Loading ...
Loading ...