Loading ...
Loading ...
Loading ...
Any changes or modifications not expressly approved
by the party responsible for compliance could void the
user's authority to operate this equipment. This device
complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) This device
must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
FCC WARNING
Read this manual carefully and save it for
future reference.
Record Full-Length Videos
Get unlimited full-length video recordings.
Smart AI Detection
Detect people, packages, vehicles, and more.
Back-to-Back Event Recording
Capture everything without 5-minute gaps.
Exclusive Discounts
Get exclusive discounts on Wyze products.
Subscribe or learn more at my.wyze.com.
GET BETTER SECURITY WITH
CAM PLUS
IN THE BOX
Disclaimer: The products, accessories, user interfaces, etc. illustrated
in this guide are intended for reference only. Due to product updates,
the actual product and the illustrations in this guide may vary.
Wyze Video Doorbell v2 (Wired) × 1
Wyze Doorbell Chime Controller × 1
Wall Plate × 1
Wedge × 1
Wire Caps × 3
Extension Wires × 2
Long Screws × 2 & Short Screws × 2
Wall Anchor × 2
Quick Start Guide × 1
CHIME CONTROLLER INSTALLATION
You need to turn off the power to your doorbell
before beginning installation.
1
Open the Wyze app and tap the + sign on the top
left corner of the Home screen. Click Add Device >
Cameras > Wyze Video Doorbell v2.
Wyze Video Doorbell requires basic electrical wiring
knowledge for installation. If you are outside of North
America, installation and wiring must be performed by
a licensed electrician.
Follow along in the Wyze app for the setup and
installation process. Make sure to follow your local
codes and laws related to electrical work. If local
codes or laws prohibit you from self-installing or if you
are uncomfortable with basic electrical wiring, consult
a licensed electrician.
Apple logo and App Store are trademarks of Apple
Inc., registered in the U.S. and other countries and
regions. Google Play and the Google Play logo are
trademarks of Google LLC. Wyze and Wyze Video
Doorbell are trademarks of Wyze Labs, Inc.
SETUP
WARNING!
1
Download the Wyze app and sign in or create
an account.
2
Micro SD
6
Lens
Microphone
Doorbell Button
1
2
3
Status Light
4
Speaker
MicroSD Slot
(MicroSD not included)
Setup Button
5
6
7
Screw Terminals
8
Front Side
SETUP
7
8
Back
1
2
3
4
5
DOORBELL INSTALLATION
Place the wall plate at your desired mounting
location and mark the screw holes. Remove the wall
plate then drill the screw holes and insert the wall
anchors.
1
STATUS LIGHT GUIDE
Flashing Orange
Waiting for connection
Solid Orange
The device is powered
Solid Blue
Connected
Alternating
Orange/Blue
Firmware is updating
Pulsing Blue
Motion detected
NEED HELP?
Contact our Support Team:
https://wyze.com/support
Join the Community:
https://wyze.com/community
Scan the QR code
to learn more
Tip: The recommended installation height is 1.2 meters
from the ground.
approx.
4.3 feet
WYZE门铃二代
105g无光铜
风琴折
曹佳丽
产品名
CMY K
100*65mm
规格:
WVDWDV2-
KSZP01 V1.0
物料编码:
040600600221
UPC:
型号:WVDWDV2
审核
批准
2022.08.15
创建 V1.0
Extension Wires
Wall Plate Wedge
Press the doorbell against the wall plate and slide
down to secure in place.
To remove the doorbell, press the doorbell in and
slide it up before pulling away from the wall plate.
3
Pass the wire from the wall through the middle of
the wall plate. Then screw the wall plate to the wall.
Note: The wedge can be installed here if needed.
2
Please follow the steps in the Wyze app for
specific installation steps.
2
Wyze Doorbell Chime Controller
Tip: Gently slide off the
cable cover before use.
The micro USB port on the back of the doorbell should
not be used as a power source for this device.
Removal of the port's rubber cover may void the
warranty and is not recommended.
or television reception, which can be determined by
turning the equipment o and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and
receiver.
– Connect the equipment into an outlet on a circuit
dierent from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV
technician for help.
Your Wyze product is covered by a one-year limited
warranty. You can view the limited warranty terms at
https://wyze.com/return-warranty-policy or request a
copy by contacting Wyze at +1 (206) 339-9646.
WARRANTY INFORMATION
Wyze Doorbell Chime Controller must be installed
before Wyze Video Doorbell is used. Failure to install
the controller may void the warranty and is not
recommended.
In order to comply with FCC radiation exposure limits,
this equipment must be installed and operated to
provide at least 20 cm separation from the body at all
times. This transmitter must not be co-located or
operated in conjunction with any other antenna or
transmitter.
This device contains licence-exempt transmitter
(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada’ s licence-exempt RSS
(s). Operation is subject to the following two conditions:
(1 )This device may not cause interference.(2)This device
must accept any interference, including interference
that may cause undesired operation of the device.
L’ émetteur/récepteur exempt de licence contenu dans
le présent appareil est conforme aux CNR d’ Innovation,
Sciences et Développement économique Canada
applicables aux appareils radio exempts de licence.
L’ exploitation est autorisée aux deux conditions
FCC RADIATION EXPOSURE
STATEMENT
ISED COMPLIANCE STATEMENTS
suivantes :(1)L’ appareil ne doit pas produire de
brouillage; (2)L’ appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est
susceptible d’ en compromettre le fonctionnement.
This equipment complies with IC RSS-102 radiation
exposure limits set forth for an uncontrolled environ-
ment. This equipment should be installed and operated
with minimum distance 20cm between the radiator and
your body.
Cet équipement est conforme aux limites d'exposition
aux radiations IC CNR-102 établies pour un environne-
ment non contrôlé. Cet équipement doit être installé et
utilisé avec une distance minimale de 20cm entre le
radiateur et votre corps.
If you can't use the extension wires due to space
limitations, connect the wires from the wall directly to
the screw terminals on the doorbell.
Use the screwdriver to loosen the screws on the back
or your doorbell and attach the forked end of the
extension wires to the screws. Then tighten the
screws.
3
4
Loading ...
Loading ...
Loading ...