Loading ...
Loading ...
Loading ...
14
B. Checks Before Installation
• Visually inspect the exterior of the shipping containers and immediately report any
damage to the carrier. Upon opening the containers, any concealed damage should
also be immediately reported to the carrier.
• Remove the shipping carton, tape, and packing material. If any are left in the icemaker
or remote condensing unit, they will not work properly.
1. Icemaker
• See the nameplate on the rear panel. Check that your voltage supplied corresponds
with the voltage specied on the nameplate.
• Remove the panels to prevent damage when installing the icemaker. See "II.C. How to
Remove Panels."
• Remove the package containing the accessories.
• Remove the protective plastic lm from the panels. If the icemaker is exposed to the sun
or to heat, remove the lm after the icemaker cools.
• Check that the refrigerant lines do not rub or touch lines or other surfaces.
• The icemaker can be installed on a dispenser unit or ice storage bin as listed below:
Hoshizaki Icemaker Dispenser Unit or Ice Storage Bin Width
FS-1001MLJ-C
FS-1500MLJ-C
30" wide or wider
FS-1022MLJ-C 22" wide or wider
For further options, contact your local Hoshizaki distributor.
• NOTICE! The icemaker must be connected to the appropriate Hoshizaki Remote
Condensing Unit listed below. Connection to another remote condensing unit will
void the warranty.
Hoshizaki Icemaker
Hoshizaki Remote
Condensing Unit
FS-1001MLJ-C
FS-1022MLJ-C
SRC-10J
FS-1500MLJ-C SRC-14J
2. Remote Condensing Unit
• See the nameplate on the remote condensing unit. Check that your voltage supplied
corresponds with the voltage specied on the nameplate.
• Remove the panels to prevent damage when installing the remote condensing unit. See
"II.C. How to Remove Panels."
• Remove the package containing the accessories.
• Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the
fan blade(s) turn freely.
• Check that the compressor is snug on all mounting pads.
Loading ...
Loading ...
Loading ...